New Members: Be sure to confirm your email address by clicking on the link that was sent to your email inbox. You will not be able to post messages until you click that link.

ACP

Oak
Oak ✭
in Other Charting Tools
Hi,

I have Channels and TL on my ACP chart. When I try to add one new TL - In the Channel - then the channel is selected.
How can I avoid that?

Best Regards
H.

Comments

  • lmkwin
    lmkwin ✭✭
    Is the TL in annotations? It should just allow you to place the beginning and end of the TL by clicking. Do you have the Horizontal Lock checked off. Maybe that is the culprit? I don't use ACP much other than to look at it to try and assist other users with questions. I just went to ACP and added a Channel and a couple TL without them snapping to anything else, but maybe I didn't do what you are doing? Maybe close the Channnel by X'ing out of the settings? Then go to TL?


Categories